Hot Wire Foam Fusion Foam Fusion 8oz

Our Foam Fusion is the ultimate foam glue for EPS and XPS! It permeates the foam and bonds around its cells. Other glues containing solvents will dissolve foam over time, but our formula is nontoxic and solvent-free. Our glue is not affected by heat or cold as with glue guns, and it does not expand.

It works with most rigid foams including polystyrene foams, like Styrofoam, white beaded EPS foam, and XPS foams (blue and pink board). Foam Fusion bonds foam to almost any porous surface and is easy to apply - simply brush or squeegee on. Apply a very thin layer on each side - it goes a long way. Available in 4 sizes.

Hot Wire Foam Factory tools will cut through this glue.

What customers are saying: "I tried the sample of Foam Fusion, looked at it, and thought I could substitute Elmer’s glue for it. When I did my project, I was very sorry I tried the substitution. Two weeks later, the foam pieces were falling apart with the white glue being totally wet like when I poured it. I had the HWFF people explain that Elmer’s (or plain white glue) is air dry, while Foam Fusion is a chemically drying product. I will never make that mistake again, and I wish I had the two wasted weeks back!" - Michael Kerschner, Professional Haunt Builder, Amherst, OH

Available in 4 sizes:
Coverage: (Best to squeegee on a thin layer on both sides. A roller applies too much glue)
8 oz   = 50 square feet (25 square feet x 2 sides)